Find Safe Operating Conditions
A single design point says little about a well that changes through its life. RodSim Dynamics runs the range and reports which limits fail.
Run RodSim Dynamics on PERM-3304. Which operating conditions stay inside the limits?
- execute-simulation
- poll-job
- get-simulation-results
1,038 of 1,221 cases stay inside the limits. Gearbox load causes most failures, above 5.5 SPM at low pump intake pressure.
| Cases | |
|---|---|
| Inside all limits | 1,038 |
| Over gearbox limit | 111 |
| Over rod loading limit | 52 |
| Under rod min stress | 20 |
Example result
Read the Result
Open the run in PetroBench to see the cases on the grid.
- 1
execute-simulationStarts a dynamic run from the current design.
- 2
poll-jobWaits for the run to finish.
- 3
get-simulation-resultsReads pass and fail counts by limit across the sweep.
More Workflows
-
Downsize a Pump Before a Rod Pull
Rods are coming out for offset frac protection. Use the rig visit to test smaller pumps against recent production in RodSim.
-
Diagnose a Gearbox Overload
A well keeps shutting down on gearbox alarms. Read the design, the production and the last fluid shot in one prompt, then test a fix in RodSim.
Run This on Your Own Wells
Your PetroBench account team turns on MCP access for your organization. Then ask your first question in plain words.
